Attempted a simple 2d mapping mission with the Air2s. DD goes through the pre-flight o.k. Then it takes off for several feet and hovers, does a camera calibration and at the same time gives an error message and says to push the “play” button to continue the flight. When it goes into this error mode it switches from autonomous to manual. After pushing the play button it goes back into autonomous, then immediately displays the error again. Restarting, rebooting, etc. has had not effect. I have done several mapping missions with a P4pv2 at this same location without a problem. Any help regarding the Air2s will be appreciated. (I have done all of the standard troubleshooting. Firmware, programs are all up to date.)