So I’m using the trial version to see how the Air 2S works with the app. I’ve mapped 2 areas with automated flight and I had a few settings off so it’s a bit blurry.
I’m trying to do it again and I can’t get it to take off. I’ve created a new project, new maps, disconnected everything, restarted….
I got the drone to take off once but it got to 100 ft and just hovered. I’ve got it set to 250 ft but it won’t fly. It gets all the way through the pre flight check list and then when I hit start flight, it will sometimes say drone initializing but it always just sits. If I switch to manual and take off, I can’t switch back to automated once it’s in the air.
Any idea on why this is happening?