Having trouble with DJI Air2s out of the box

I setup a mission, and then go to start it. I’m getting an error, I googled and searched around a little bit to try and trouble shoot.

It passes the pre-flight, takes off and then after rotating the camera down it displays

“Calibrating camera…”
and then it stops because of an error, Resuming the mission yields the same result… Any help with this? pointing in the correct direction? Heres a screen cap of the error

1 Like

What device and iOS version?

Is DJI Fly updated and completely closed before starting DroneDeploy?

Was the mission created on a computer or on the mobile device?

1 Like

ugh, newbie stuff. I found advice to format the SD in the device… did that, all is good.