Manual Adjustment of Walkthroughs

Currently, in walk-through mode, it just uses the GPS on your device to locate all of the areas other than the starting and ending points. In a building (especially not on the top floor) this is not super accurate. Without adding additional cost to an already cost-prohibitive application, I’d like to propose either the usage of Procore locations and the barcodes associated with them to be used and synced to specific rooms in the plan, or the ability to manually mold the walkthrough to specific locations. For example similar to how we use the GCP tagging, we should be able to manually pull edges of a walkthrough to the specific location instead of sending the request in and waiting for it to get done by your staff.

1 Like