I have some tasks to do with my map, are all of these possible on drone deploy?
above ground birdseye survey of entire site with the following survey measurements plotted post flight
crane A – centre of crane base to jib length of 28m (radial plot)
crane A – radial measurement from 28m jib radial plus 3
meters to identify deflection zone (radial plot)
crane B – centre of crane base to jib length of 25m (radial plot)
crane B – radial measurement from 25m jib radial plus 3
meters to identify deflection zone (radial plot)
side elevation of
a. whole site from Hampton street roadside looking sw.
Measurement plot taken of both cranes A and B with the following
crane A at jib height (20.8m from base)
crane A jib length from base at 28m in to centre of site
crane B at jib height (20.8m from base)
crane B jib length of 25m in to centre of site
measured plot between crane A jib height and crane B jib height when jibs are pointing into the centre of the site. To check for jib bind.
3. side elevation of crane B and building A with the following plots
height from ground to top of chimney on building A
distance from centre of crane A to building A chimney at jib height (20.8m), checking for potential collision hazard
height from crane B base to top of building A chimney
see appendix A for proposed plot measurement drawing
Appreciate it, thanks