looking for some tips as to best map this pond that is part of an RV park we are mapping.
I know water is hard to map and the water doesnt necessarily matter but just looking for tips to make it as best as possible
Thanks
looking for some tips as to best map this pond that is part of an RV park we are mapping.
I know water is hard to map and the water doesnt necessarily matter but just looking for tips to make it as best as possible
Thanks
There shouldn’t be anything special about mapping this. I would suggest not to use any kind of oblique imagery because the reflections that it picks up with cause the surface of the water to peak and pit. Beyond that a point cloud editing software would be a good tool to allow you to remove the points inside of the perimeter where the land meets the water. You can then re-drape the ortho over the edited points and/or model and get a nice 3D model.