Boundary Overlays on to 2D and 3D Maps

I was wondering if you can basically draw smaller boundary lines onto the 2D and 3D models. My specific purpose would be to create a map and then to draw out 6 different lots inside the map. Is this possible?

Hi @wghender,

Thanks for swinging by the DroneDeploy Forum. I’m not quite sure if you’re looking to do area or volume measurements with the lots on your map, but have you taken a look at our Annotations support page?

Cheers,
Christina

Like Christina said, check out the invitations. I would use the distance measurement tool to “two-tape” in a corner or two and then draw lines with your specific measurements from there. You could also use the area tool to calculate the area and then split it into the lot sizes that you want.