A lap missed

Hello everyone. Yesterday I try to make a 65 hectares area to map. The drone started the motors, flew until reach 100 m, so it went to first point. But something got wrong, when it going to start the first lap, he turned back and started in second lap. And my map was planned ok, I dont know what happened. See the chart below:

It not went the first lap near the road in horizontal.

That is strange. There may have been some interference there that day.

Usually you can bring it back and turn the drone, controller and app off and back on and clear this out and try it again.

I tried in the same day, but didnt work. I think that I’ll make larger a little, and try this week again.